|
Tumbling with DD Ceramic Porcelain Media |
|
This is a wet tumbling process. The tumbler used must be able to handle a wet load.
1. Don’t overload your tumbler. Follow manufacturers directions for load size.
2. Equal volumes of brass, media and solution produce best results.
3. Your brass should be clean in three hours of tumbling, or less.
4. The DD Ceramic Porcelain Media does NOT wear out. Don’t loose it when separating brass.
5. Do not re-use the tumbling solution. It is a single use item.
6. A simple water rinse with three clean water changes is all that is needed to complete the process.
7. The recommended mix ratio of solution concentrate to water is 1/2 oz. : 1 gallon water. |
 |
|
|
Only genuine Big Lube®LLC bullet molds have this feature. |
|
Big Lube®LLC manufactured Six Cavity Professional bullet molds have this little threaded adjustment on the block under the sprue lever cam. By adjusting this stud with an alan wrench to maintain minimum gap between the sprue cam lever and the mold block, full travel and use of the sprue cutting cam is assured.
|
 |
|